You can simply remove or add components when the computer is still operating. This simply means you can’t remove or add any component when the computer is still running. To set the primary drive, you can easily access the settings directly from the BIOS of the computer. Each drive is directly connected to the motherboard. SATA drives don’t necessarily need jumpers to operate. The system of the computer doesn’t have any idea on which is the main drive and which one they should load the OS. To connect the different IDE drives, it is necessary to chain the ribbon cables from one cable to the other. In most computer systems, it is manageable to have more than just one hard drive. The connection type for SATA is a serial connection. The data transfer rate for SATA is up to 600MB/s. The data transfer rate for IDE is up to 133/s The first revision of SATA was released back on January 7, 2003. SATA (Serial Advanced Technology Attachment) is a computer bus port that connects host bus adapters directly to mass storage devices like optical drives, solid-state drives, and hard disk drives. IDE (Integrated Drive Electronics) is an electronic standard interface that allows connection between a computer’s bus motherboard and the storage device like the computer’s disk. Though they both have the same similarities of serving the same purpose, SATA is the best to use nowadays as manufacturers only create motherboards that have the SATA connectors while few create motherboards that have the IDE connectors. The newest SATA generation (SATA 3.0), which was officially released on May 27, 2009, speed rate is 600 MB/s where motherboards and hard drives are commonly used. The first SATA generation speed rate was 150 MB/s, just the same as PATA/133. SATA was improved with better speed rates. The parallel transfer wire mode can reach a maximum speed of 133/s. The data transfer speed rate for the IDE ranges between 5MB/s and 133MB/s. On the other hand, SATA offers a serial connection to directly connect the computer bus to the storage device. The main difference between the two is that IDE offers a parallel connection to directly connect the storage device to the interface of the computer bus. Both IDE and SATA use certain different types of connectors, so they can’t be interchanged without the use of an adapter. Nowadays, SATA is used by most people because it is very easy, less complicated, and convenient to use and figure out. On the other hand, SATA, which stands for Serial Advanced Technology Attachment, is just an interface that aids in data transfer between storage devices and a computer’s bus. IDE, which simply stands for Integrated Drive Electronics, is just a connector used for storage devices that are directly linked to a personal computer. The IDE is just an older version of SATA.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |